Auto-Off Function; Auto-Hold Function; Hold Function; Vibration Signal - TESTO Saveris 0560 1020 Instruction Manual

8.3.3

Auto-Off function

You can enable or disable the Auto-Off function via the paired mobile device.
When the Auto-Off function is enabled, the testo Saveris multifunction
handle automatically switches off when it has not been used for
10 minutes to save energy.
When the Auto-Off function is disabled, the instrument automatically
switches off when it has not been used for 2 hours.
8.3.4

Auto-Hold function

You can enable or disable the Auto-Hold function via the paired mobile device.
For instrument variants with an integrated temperature stabilization
mode (section 9.2.2), the
When the Auto-Hold function is enabled,
measuring value flash on the display of the testo Saveris multifunction
handle. The measured values are automatically held by the instrument
after the acclimatization time. The generated measuring value and
Auto-Hold
8.3.5

Hold function

Measured values can be held manually using this function.
8.3.6

Vibration signal

You can enable or disable the vibration signal via the paired mobile device.
If the vibration signal is enabled, the testo Saveris multifunction handle
emits a haptic vibration signal as soon as a reading is held via the Auto-
Hold function.

9 Operation

To carry out measurements, fit the appropriate probe measuring tip onto the
testo Saveris multifunction handle. The testo Saveris multifunction handle
detects the probe type which is attached. This ensures that appropriate
measurement results are generated for the measurement in each case (quality
control).
Auto-Hold
are shown on the display.
function cannot be configured.
Auto and the current
9 Operation
13