Gateway - RAKwireless RAK7249 Configuration Manual

RAK7249/58
Minimum and maximum allowed data-rate
Note the DR_0, to DR_15 values represent a bits/s value and max payload size. Those are
dependent on your region of operation and the bandwidth and SF used. However as they
are predefined by the LoRa Alliance the menu does not list the full parameter values. Please
refer to the official documentation for details.
Network ID
The ID of the network to be advertised to end devices in case you want to have roaming to
other networks
Downlink Tx Power
This is the maximum power in dBm the Gateway is allowed to use when transmitting frames
to the nodes. It is region specific (for example EU – 14dBm)
Device-status request interval
The time in seconds between node status request messages sent by the Gateway. Default
value of 0 (disabled status requests).

Gateway

3.4.2
In this section you can add and External Gateways to work with your LoRa Network Server.
This way packets forwarded by the listed Gateways will be forwarded as though they were
within the range of this device. Refer to Figure 11 for an overview of the section window:
Figure 14 | Adding Gateways to the LoRa Network Server
Below is a short explanation of the main parameters:
RAK LoRaWAN Industrial Gateway Configuration Guide
17