Xx.xxf (C); Tot; Tx Pwr; Ver.dsp - Yaesu FTM-6000R Advance Manual

28 xx.xxF (C)

Displays the temperature near the final stage of the transceiver
If the temperature is about 50°F (10°C) or less, "LOWTMP" is displayed.

29 TOT

Set the timeout timer.
Set the transceiver to automatically return to receive mode after transmitting continu-
ously for a certain period of time. The TOT function limits inadvertent transmission of
unnecessary signals, and unwanted battery power consumption (time-out timer func-
tion).
OFF
1 MIN / 2 MIN
3 MIN / 5 MIN
10 MIN / 15 MIN
20 MIN / 30 MIN
The beep sounds at about 10 seconds before returning to receive mode automatically.

30 TX PWR

Select the transmit power output level
The transmit power can be reduced to save on energy consumption when communi-
cating with a nearby station.
HIGH
MID
LOW

31 VER.DSP

Display the software versions of the transceiver.
Switch between "Main" and "Panel" by turning the DIAL knob.
M x.xx
P x.xx
32 xx.xV
Indicates the DC Supply Voltage

33 WIDTH

Set the Modulation Level
The modulation can be set to half of its usual level. Select "WIDE" for normal amateur
operation.
WIDE
NARROW
The TOT time is deactivated.
Set the transceiver to automatically return to receive mode
after transmitting continuously for the set period of time.
50W
25W
5W
The software versions of "Main" is shown.
The software versions of "Panel" is shown.
Normal transmit modulation level.
Modulation is half of the normal level.
32