Table of Contents
Advertisement
Chapter 4
4.11 IDE HDD AUTO DETECTION
When users can not find the Hard Disk information, it is very helpful to use this option.
1.
Choose this item and press <Enter>.
2.
After couple seconds, the screen will appear the Hard Disk information and
following message:
"SELECT PRIMARY MASTER OPTION(N=SKIP): N"
3.
Enter Y or N to confirm the acceptance then enter.
4.
The process will repeat for Primary Slave, Secondary Master and Secondary Slave
Hard Disks.
4.12 SCSI HARD DISK INSTALLATION
In Standard CMOS Setup Utility, select hard disk type to be "Not Installed". In
Advanced CMOS Setup Utility, Disable "Adapter ROM Shadow DC00". On the SCSI
Controller card, set the jumpers which configure the SCSI card BIOS segment address
located at DC00 or DE00. Format the SCSI disk by the Formatter provided in the SCSI
BIOS.
4.13 SAVE & EXIT SETUP MENU
When you select this function, the following message will appear at the centre of the
screen to assist you to Save data to CMOS and Exit the Setup.
4.14 EXIT WITHOUT SAVING MENU
When you select this function, the following message will appear at the centre of the
screen to assist you to Abandon all Data and Exit Setup.
40
Save to CMOS and Exit (Y/N)?
Quit Without Saving (Y/N)?
Advertisement
Table of Contents
