Failur E Displa Y An D Inspection - Apelson UBIND60FLC User Manual

zones " together , the display will show the remaining time of alarm as
first priority. Press cooking zone to show the remaining time of
switch off timer.

Failur e Displa y an d Inspection

I f an abnormalit y come s up , th e inductio n ho b will ente r th e protectiv e stat e
automaticall y an d displ ay correspondin g protectiv e codes:
Error
Message
No pot or pot not suitable;
ER03 Water or pot on the glass over the control
The connection between the display board and the
left mainboard is fail (the cooking zone which
F1E
indicator showing "E")
Coil temperature sensor failure. (the cooking zone
F3E
which indicator showing "E")
Mainboard temperature sensor failure. (the cooking
F4E
zone which indicator showing "E")
Temperature sensor of the ceramic glass plate is
E1E
high
Temperature sensor of the IGBT is high
E2E
Abnormal supply voltage(too high)
E3E
Abnormal supply voltage (too low)
E4E
Temperature sensor failure(the cooking zone which
E5E
indicator showing "E")
The above are the judgment and inspection of common failures.
Please do not disassemble the unit by yourself to avoid any dangers and
damages to the induction hob and please contact the service department.
Possible Cause
14
What to do
Replace the pot;
Clean the user interface
1.Connection cable not correctly plugged or
defective;
2.Replace the mainboard or power .
Replace the coil sensor
Replace the mainboard
Please restart after the induction hob cools
down.
Please restart after the induction hob cools
down.
Please inspect whether power supply is normal;
Power on after the power supply is normal.
Please inspect whether power supply is normal;
Power on after the power supply is normal.
Connection cable not correctly plugged or
assemble defective;