Related Manuals for Apelson UBIND60CLCT
Summary of Contents for Apelson UBIND60CLCT
- Page 1 Touch Control Induction hob UBIND60CLCT INDUCTION INDUCTION INDUCTION INDUCTION...
- Page 2 INDUCTION INDUCTION INDUCTION INDUCTION [01] [03] x 4 [02] x 4 Note: Items 2 and 3 are pre-fitted in the factory there is no assembly of these components required. [04] x 1...
- Page 3 Touch Control Induction Hob UBIND60CLCT Installation Installation...
-
Page 4: Table Of Contents
Let's get started ... Getting started... Safety Before you start more detail... Product functions Operation Care maintenance Troubleshooting Recycling disposal Technical legal information Declaration conformity Appendix Installation... -
Page 5: Getting Started
Getting Started ... Safety Before start INDUCTION INDUCTION INDUCTION INDUCTION... - Page 6 Safety These instructions are for your safety. Please read through them thoroughly prior to installation and retain them for future reference. • All installation work must be carried out by a competent person or qualified electrician. • This appliance must be installed correctly by a suitably qualified person, strictly following the manufacturer’s instructions.
- Page 7 Safety Please dispose of the packing material carefully. Do not use flammable sprays in close vicinity to the appliance. We also recommend that great care be taken during use and cleaning. Read the cleaning and maintenance sections for this appliance carefully. A steam cleaner is not to be used.
- Page 8 Safety WARNING: Unattended cooking on a hob with fat or oil can be dangerous and may result in fire. NEVER try to extinguish a fire with water, but switch off the appliance and then cover flame e.g. with a lid or a fire blanket.
- Page 9 Before you start Before you start To avoid the risks that are always present when you use an electrical appliance it is important that this appliance is installed correctly and that you read the safety instructions carefully to avoid misuse and hazards. Please keep this instruction booklet for future reference and pass it on to any future owners.
-
Page 10: In More Detail
more detail... Product functions Operation Care maintenance Troubleshooting Recycling disposal Technical legal information Declaration conformity... -
Page 11: Product Functions
Product functions Special functions Protection from over-heating > A sensor monitors the temperature in the cooking zones. When the temperature exceeds a safe level, the cooking zone is automatically switched off. Residual heat indicator > When the hob has been operating for some time, there will be some residual heat. -
Page 12: Operation
Operation Operation Reference Description Zone position Child lock ON / OFF Power regulating key (reduce) Power regulating key (increase) Timer Heating zone power Heating Zone Max. Power (230V~) 2000W 1500W 2000W 1500W... - Page 13 Operation Operation A Word on Induction Cooking Induction cooking is a safe, advanced, efficient, and economical cooking technology. It works by electromagnetic vibrations generating heat directly in the pan, rather than indirectly through heating the glass surface. The glass becomes hot only because the pan eventually warms it up.
- Page 14 Operation Choosing the right Cookware >Only use cookware with a base suitable for induction cooking. Look for the induction symbol on the packaging or on the bottom of the pan. >You can check whether your cookware is suitable by carrying out a magnet test. Move a magnet towards the base of the pan.
- Page 15 Operation Always lift pans off the Induction hob – do not slide, or they may scratch the glass. Using your Induction Hob To start cooking 1. Touch the ON/OFF control. After power on, the buzzer beeps once, all displays show “ – “, indicating that the induction hob has entered the state of standby mode.
- Page 16 Operation Using your Induction hob If the display flashes alternately with the heat setting This means that: > you have not placed a pan on the correct cooking zone or, > the pan you're using is not suitable for induction cooking or, >...
- Page 17 Operation Safety mode (Child lock) > You can lock the controls to prevent unintended use (for example children accidentally turning the cooking zones on). > When the controls are locked, all the controls except the OFF control are disabled. To lock the controls Touch the key lock control for 3 seconds.
- Page 18 Operation 3. Set the time by touching the “-“ or ”+” control of the timer. Hint: > Touch the “-“ or ”+” control of the timer once to decrease or increase by 1 minute. > Touch and hold the “-“or ”+” control of the timer to decrease or increase by 10 minutes.
-
Page 19: Care And Maintenance
Care and maintenance Warning Always switch off the electricity supply before performing maintenance work. In the event of a fault, contact customer services. Care and maintenance Care Damaged power cables should be replaced by a competent person or qualified electrician. For domestic use only. - Page 20 Care and maintenance Avoid banging pots and pans down on the hob. The ceramic surface is tough but not unbreakable. Do not put detergents or flammable materials beneath the hob. Care and maintenance Appliance cleanliness Caution • Avoid rubbing with any abrasive or with the base of the pans, etc, as this will wear the markings on the top of the induction hob over time.
-
Page 21: Troubleshooting
Care and maintenance Troubleshooting If an abnormality comes up, the induction hob will enter the protective state automatically and display corresponding protective codes: Error Possible Cause What to do Message No pot or pot not suitable Choose the suitable pan ER03 Water or pot on the glass over the control Clean the user interface... -
Page 22: Recycling And Disposal
Technical and legal information Recycling and Disposal Environmental Protection Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice. The symbol on the product or its packaging indicates that this product cannot be treated as normal household waste. -
Page 23: Technical And Legal Information
Technical and legal information Electrical Requirements Any permanent electrical installation must comply with the latest I.E.E. Regulations and local electricity company regulations. For your own safety a qualified electrician or contractor who is on the roll of the National Inspection Council for Electrical Installation Contracting (NICEIC) should undertake the electrical installation. -
Page 24: Ce Declaration Of Conformity
CE Declaration of conformity CE Declaration of Conformity UBINDJV60B Induction hob 2014/35/EU: 2014/30/EU: The Manufacturer has a policy of continuous product improvement, it reserves the right to adapt and carry out any modification considered necessary without prior warning. - Page 25 Appendix Installation...
- Page 26 Installation Hob installation Caution > The induction hotplate must be installed by qualified personnel or technicians. Please never conduct the operation by yourself. > The hob will not be installed directly above a dishwasher, fridge, freezer, washing machine or clothes dryer, as the humidity may damage the hob electronics >...
- Page 27 Installation Electrical connection Caution > This hob must be connected to the mains power supply only by a suitably qualified person. > Before connecting the hob to the mains power supply, check that: 1. the domestic wiring system is suitable for the power drawn by the hob.
- Page 28 Installation Clearance Warning Good ventilation is required around the appliance for easier dissipation of heat and low power consumption. Sufficient clearance is required around the appliance. The gap between the hob and any cupboard above it should be at least 750mm. 750mm 750mm At least...
- Page 29 Installation Technical Specification Cooking zones 4 zones Supply voltage 220-240V~ Total power 6400W Product size L×W×H (mm) 590×520×56.5 Build-in dimension A×B (mm) 565×495 Weight and Dimensions are approximate. Because we continually strive to improve our products we may change specifications and designs without prior notice.
- Page 30 Installation Installation A(mm) B(mm) C(mm) 50 mini 20 mini Air intake Air exit 5mm Before you install the hob, make sure that > The work surface is square and level, and no structural members interfere with space requirements. > The work surface is made of a heat-resistant material. >...
- Page 31 Installation Installation When you have installed the hob, make sure that > The power supply cable is not accessible through cupboard doors or drawers > There is adequate flow of fresh air from outside the cabinetry to the base of the hob >...
- Page 32 Installation Cut out worktop to supplied dimensions shown in (fig 1) with suitable equipment and seal the cut edge as appropriate [04] [04] x 1 Stretch out the supplied seal along the underside edge of the hob, ensuring the ends overlap.
- Page 33 If your product breaks down. To arrange an in guarantee service call, please contact customer servies on the following numbers. UK & Northern Ireland Phone: 0344 800 1128* Email: uksupport@apelson.co.uk Web: www.spareszone.co.uk Republic of Ireland (ROL) Phone: 014475261 Email: uksupport@apelson.co.uk...
- Page 34 Notes...
- Page 36 Apelson Appliances UK Ltd Unit 3 Normandy Landings Pope Street Castleford WF6 2AG United Kingdom...
Need help?
Do you have a question about the UBIND60CLCT and is the answer not in the manual?
Questions and answers