Table of Contents
Advertisement
8.4 Command Control via the Network
You can confi gure and control the projector via the network using RS-232C
commands.
Communication Port
The following two ports are assigned for the command control.
TCP #23 (Network Control Port1 (Port: 23))
TCP #9715 (Network Control Port2 (Port: 9715))
NOTE
• Command control is available only via the specifi ed port above.
Command Control Settings (&51)
Confi gure the following items from a web browser when command control is used.
Example: If the IP address of the projector
is set to 192.168.1.10:
1) Enter "http://192.168.1.10/" into the
address bar of the web browser, and
select Projector Web Control from the
selection window.
2) Enter your user name and password,
and then click the [OK].
3) Click the [Port Settings] on the main
menu.
4) Click the [Enable] check box to open
Network Control Port1 (Port: 23) to use
TCP #23. Click the [Enable] check box
for the [Authentication] setting when
authentication is required, otherwise clear
the check box.
5) Click the [Enable] check box to open
Network Control Port2 (Port: 9715)
to use TCP #9715. Click the [Enable]
check box for the [Authentication]
setting when authentication is required,
otherwise clear the check box.
105
8. Other Functions
QM00973-1
Advertisement
Table of Contents
