Table of Contents
Advertisement
9. Troubleshooting
Phenomenon: The schedule is not executed correctly.
Item to be checked
Is the projector turned on?
Is STANDBY MODE set to
NETWORK(WOL) or SAVING?
Is the time set correctly?
Is the image data to be displayed
in the schedule function
registered?
(When the event of My Image is
set.)
Is the message data to be
displayed in the schedule
function registered?
(When the event of Messenger is
set.)
Is the light source of the projector
lighting?
Is the program to be executed
set correctly?
Are there any events set at the
same time?
* The schedule function may not operate correctly depending on the status of the
projector.
Solutions
Turn on the projector.
The schedule function is not available when
STANDBY MODE is set to NETWORK(WOL)
or SAVING. If you want to use the schedule
function in the standby mode, set to QUICK
START or NORMAL.
Check the settings of Date and Time.
Register the image data to be displayed with
the projector by using exclusive application
software.
Register the message data to be displayed with
the projector by using exclusive application
software.
The event of My Image, Messenger and Blank
are not executed when the light source is
not lighting. Set the program of the schedule
function so that the event of My Image,
Messenger and Blank can be executed when
the light source is lighting.
Check the settings of Schedule Settings of the
Projector Web Control.
Some events cannot be executed at the same
time.
Set them to be executed at the different time or
change the order.
118
QM00973-1
Advertisement
Table of Contents
