Table of Contents
Advertisement
Communication settings
4. Data reply: 1Dh + xxxxh
When the projector receives the GET command correctly, the projector returns the response
code and 2 bytes of data.
Note: For connecting the projector to your devices, please read the manual for each devices, and
connect them correctly with suitable cables.
Note: Operation cannot be guaranteed when the projector receives an undefined command or
data.
Note: Provide an interval of at least 40ms between the response code and any other code.
Note: The projector outputs test data when the power supply is switched ON, and when the light
is lit. Ignore this data.
Note: Commands are not accepted during warm-up.
Note: When the data length is greater than indicated by the data length code, the projector
ignore the excess data code. Conversely when the data length is shorter than indicated by
the data length code, the projector returns the error code to the computer.
Command control via the network
When the projector connects network, the projector can be controlled with RS-232C commands from
the computer with web browser.
For details of RS-232C commands, refer to RS-232C Communication / Network command table.
Connection
1. Turn off the projector and the computer.
2. If you use wired LAN, connect the projector's RJ45 port to the computer's LAN or HDBaseT
port with a LAN cable. Use the cable that fulfills the specification shown in figure.
3. Turn the computer on, and after the computer has started up turn the projector on.
Communication port
The following two ports are assigned for the command control.
TCP #23
86
LAN
• LAN cable (CAT-5e or greater)
or
• For HDBaseT connection
- CAT-5e or greater
- shielded type (connectors included)
- straight cable
- single cable
RJ45 or
HDBaseT port
Hide quick links:
Advertisement
Table of Contents
