Additional Information; Board Revision History - Arrow BeMicro CV A9 Hardware Reference Manual

Setting the I/O voltage for one of these banks sets it for all of the banks.
location of jumper J11 on the board and location of pin 1 on the right side of J11.
describes how to set the VCCIO voltage using jumper J11.

3. Additional Information

This chapter provides additional information about the document.

Board Revision History

The following table lists the versions of all releases of the Arrow Electronics BeMicro CV A9
Cyclone V FPGA Development Board.
Release Date
September 2014
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
Figure 2-3: Location of jumper J11
Table 2-13: Setting VCCIO for Banks 3A, 3B, 4A and 5B
VCCIO
2.5V
3.3V
Version
Initial release
23
J11 Jumper Location
Connect pins 2 and 3
Connect pins 1 and 2
Limited production run
Figure 2–4 shows the
Table 2–13
Description