Table of Contents
Advertisement
Available languages
Available languages
7.0 operation
Once the appliance has been plugged into a grounded electrical outlet or hard wired to a dedicated 120V power
supply, it is ready to operate.
ATTENTION: Ensure the house circuit breakers for the power supply are turned on. When initially
connecting the appliance into a power source, the appliance will perform an LED check. The appliance
will flash on and off for 5 seconds.
7.1
operating control panel
The control panel is located on the top front of the appliance.
Power
Flame & Ember Light
Control
Heater Control
Timer
F° / C° Switch
Heater Lock
Temperature
Control
Turns the appliance ON/OFF.
Controls Flame brightness and the Ember Light.
5 Settings: Flame & Ember off (FO), Ember on but Flame
off (LL), small Flame & Ember (F1), medium Flame &
Ember (F2), brightest Flame and Ember (F3).
Turns the Heater and Blower ON/OFF.
4 Settings: Heater & Blower off (HO), Blower on (BL), low
heat (H1), high heat (H2).
Timer can be programed to run appliance for specific
lengths of time (30mins. minimum to 6hrs maximum).
Hold 5
To change temperature format, Fahrenheit or Celsius.
seconds
Press and hold the Flame button
Heater button can be locked or unlocked by holding the
Hold 5
Heater button
for 5 seconds.
seconds
Press and hold the Timer button
Hold 5
will change the button to Temperature Control, or vice
seconds
versa. There are 7 temperature settings (61
75
F, 81
F, 85
F and OFF)
°
°
°
operation
for 5 seconds.
for 5 seconds. This
F, 64
F, 70
F,
°
°
°
W415-1755 / 05.03.17
EN
17
Advertisement
Chapters
Table of Contents
