Hard Wiring Installation - Napoleon NEFP24HT-HD Installation And Operation Manual

installation
EN
4.4

hard wiring installation

WARNING
!
• Turn off the appliance completely and let cool before servicing. Only a qualifi ed service person should service
and repair this electric appliance.
HARD WIRING CONNECTION
If it is necessary to hard wire this appliance, a qualified electrician must remove the cord connection and wire
the appliance directly to the household wiring. The wire and power supply breaker must be rated for 120V and a
minimum of 15Amps.
This appliance must be electrically connected and grounded in accordance with local codes, if hard wired, in the
absence of local codes, use the current CSA C22.1 Canadian Electrical Code in Canada or the current ANSI/
NFPA 70 National Electrical Code in the United States.
note:
There are 3 wires from the fireplace junction; white (neutral), black (power L1) and green (ground) that
connect to 120V power supply (breaker panel), see below.
1. Remove the securing screw from the electrical cover plate, located on the right hand side of the appliance.
2. Add an electrical box connector and feed the supply wires through the 7/8" (22mm) hole.
3. Separate the black, white and green wires that have the wire nuts on them.
4. Remove the wire nuts and secure the black wire (power L1) to the black (power L1) lead of the power supply.
Connect the white wire from the appliance to the white (neutral) wire from the power supply. Connect the
green wire to the ground wire.
5. Resecure the cover plate.
F
J
I
U
R
N
E
C
P
T
L
I
A
O
C
N
E
12
W415-1755 / 05.03.17
E
M
P
A
L
M
E
(L1)
BLACK
WHITE (N)
GREEN (G)
WIRE NUT
WHITE
BLACK
GREEN
C
H
(L1)
NEGRO
I
M
(N)
BLANCO
E
N
VERDE (G)
E
A
TUERCA DEL
White, Green and
Black wires:
Connect to 120V
power supply.
CABLE
S
P
U
BLACK
O
P
W
P
WHITE
E
L
R
Y
GREEN
NEGRO
BLANCO
VERDE