Table of Contents
Advertisement
Available languages
Available languages
5.0 finishing
WARNING
!
•
Power supply service must be completed prior to finishing to avoid reconstruction.
•
Heat vents and air openings cannot be covered in any circumstances.
5.1
glass door removal / installation
WARNING
!
•
Facing and/or finishing material must not interfere with air flow through air openings, louvres openings, operation
of louvres or doors or access for service. Observe all clearances when applying combustible materials.
•
Before door is removed, turn the appliance off and wait until appliance is cool to the touch. Doors are heavy and
fragile so handle with care.
1. Remove the 4 screws off the appliance, as shown.
2. Remove the glass front and place a soft non-abrasive surface.
3. Reverse these steps to reinstall the glass front.
5.2
log, grate and ember bed assembly removal
1. Remove the 4 screws securing the ember bed to the sides (and bottom, if applicable) of the appliance, as
shown.
note:
Some models only have two screws.
2. Lift the log, grate and ember bed up from the appliance and remove.
SCREW
SCREW
(if applicable)
finishing
SCREW
SCREW
SCREW
(if applicable)
W415-1755 / 05.03.17
EN
15
Advertisement
Chapters
Table of Contents
