Troubleshooting - EGO HT5100E Repair Manual Line

Troubleshooting

Problem
Fail to start
Soft start failure
Excessive vibration
The speed and power is
less compared with normal
use.
The switch lever doesn't
return to the original
position.
Possible Cause
Main PCB or its wires are broken
The blade is jammed when an
obstruction is stuck in the blade
and deforming the blade.
Motor failure
Gears are jammed due to
damaged teeth.
Malfunction of switch levers
Main PCB is broken
worn eccentric block，gears or
shaft
Motor is broken
Dust stuck in the switch.
HT5100E/HT6500E Hedge Trimmer
Fault Position
PCB Assembly Replace the PCB assembly.
Clear any obstructions or
Blade Set
replace the blade Set
Replace the motor and gear
Motor
Gear Set Replace the failure gears.
Switch Levers Replace the switch lever.
PCB Assembly Replace the PCB assembly.
Eccentric Block,
Replace the worn parts
Gears, Shaft
Replace the motor and gear
Motor
Switch Lever
Test & Solution
assembly.
assembly.
Clear the dust
3