Section 3. Installation - Jandy TruFit Bubbler Owner's Manual

Installation Instructions
Section 3.
1. Insert the snorkel into the bubbler body.
2. Turn the lens clockwise. Make sure it fits properly inside the
body.
Figure 6. Insert the Snorkel
Figure 7. Snorkel Installed
3. The snorkel is adjustable so that proper water flow can reach
the surface. The length of the snorkel can be trimmed so that the
plume height of the bubbler can be set to your preference.
4. Cut at least 1" at time to get the preferred plume height.
NOTE: The snorkel can be adjusted within a 45 degree angle only.
Installation
ENGLISH Page 7