Jacuzzi LLUSION 6636 Installation And Operating Instructions Manual page 17

Suction Cover/Strainer Maintenance
Clean the suction cover/strainer of hair and debris when
necessary. To do this, remove the center screw and detach
the square cover. Clean the cover by backflushing debris
from the holes. Replace the suction cover immediately after
cleaning. When reinstalling, orient the cover/strainer with
the small notch at the bottom. The gasket must be inserted
into the groove of the cover/strainer before reinstalling onto
the suction fitting.
CAUTION: Keep hair a minimum of 6 inches away from
the suction fitting at all times when the whirlpool system
is operating. Hair longer than shoulder length should be
secured close to the head, or a bathing cap should be
worn. Do not operate the whirlpool system with the suc-
tion cover removed! It is a safety device and must al-
ways be in place on the suction fitting to minimize the
potential hazard of hair and body entrapment.
SUCTION COVER/STRAINER ASSEMBLY
COVER STRAINER
SCREW
NOTCH
Lamp
All units come standard with an underwater LED light
fixture. There are no internal replacement parts for the
LED light fixture.
Replacement fixtures are available from your Jacuzzi
Whirlpool Bath
LED LIGHT ASSEMBLY
SUCTION
FITTING
GASKET
13
© dealer.
LOCKING NUT
SHELL
Jacuzzi Whirlpool Bath © BR28000B
LIGHT BEZEL
4/05