Check The Engine Oil; Check The Coolant Level - Honda 2005 CB900F Setup Instructions

21. Check the engine oil.

Before starting the engine, remove the anti-
rust coating from the engine and exhaust
system using a mild detergent and water.
Rinse with clean water.
Support the motorcycle in an upright position
on a firm, level surface.
Check the oil inspection window to be sure
the engine has oil.
If no oil is present in the window, remove the
oil filler cap and add the recommended oil to
bring the level up to between the upper and
lower level marks.
Oil recommendation: Pro Honda GN4
•
or HP4 (without molybdenum
additives) 4-stroke oil, or an equivalent
motorcycle oil.
Viscosity (weight): SAE, 10W-40
•
API classification: SF or higher. Do not
•
use oils labeled as energy conserving
on the circular API service label.
JASO T 903 standard: MA
•
Crankcase capacity: 3.5 Liters
•
(3.7 US Quarts)
Start the engine and let it idle for 3 - 5
minutes, then shut it off. Wait 2 - 3 minutes
and, supporting the motorcycle in an upright
position, check the oil inspection window. The
oil level should be between the upper and
lower level marks. If the level is low, add the
recommended oil as detailed above. Do not
add oil above the upper level mark.

22. Check the coolant level.

Check the coolant level at the reserve tank
located behind the side cover on the left side.
If required, add Pro Honda HP coolant or
an equivalent high quality ethylene glycol
antifreeze containing silicate-free corrosion
inhibitors to restore the level to the
UPPER mark.
©2005 American Honda Motor Co., Inc. - All Rights Reserved
FILLER CAP
UPPER
LEVEL
MARK
LOWER
LEVEL
MARK
UPPER LEVEL
13