Stabilator Controls - Piper PA-32R-301 SARATOGA SP Maintenance Manual

STABILATOR CONTROL SYSTEM (cont.)
7
18
8
7
1 . CONTROL COLUMN TEE B AR
2 . RIGH T FOR WA RD CA BLE
3 . LEFT FORWARD C ABLE
4 . LEFT, LOWER AFT C ABLE
5 . RIGH T, UPPER AFT C ABLE
6 . FORWAR D CLUSTER PULLEY
7 . AFT PULLEY
8 . BOLT, WASH ER, N UT & C OTTER PIN
9 . BOLT, WASH ER & NUT
10 . CAB LE RU B BLOC K
(1) To install forward stabilator cables (cont.):
(b) Connect cables to lower end of control column tee bar with bolt, washer, nut and cotter pin.
Ensure that cable is free to rotate.
(c) Connect control cable to aft cable at turnbuckle in aft section of fuselage.
(d) If installing right control cable, install cotter pin cable guard at pulley in forward area of
tunnel.
(e) Install the cable rub blocks to the spar housing located in forward area of floor opening aft of
main spar. Secure with screws.
(f) Install cotter pin cable guard at pulley cluster located in aft area of floor opening, .
(g) Install cable guard under pulley cluster located in aft area of aft floor tunnel. Secure with
screws.
(h) Set cable tension. Check rigging and adjustment per Rigging and Adjustment of Stabilator
Controls.
PIPER AIRCRAFT
PA-32R-301/301T
MAINTENANCE MANUAL
8
17 5
4
16
1 3
1 1. CA BLE GUA RD
1 2. BOLT, WA SHER (7) & NU T
1 3. BOLT, WA SHER (11 ) & N UT
1 4. FOR WA RD PULLEY
1 5. BOLT, WA SHER, NUT & COTTER PIN
1 6. TURN BUC KLE
1 7. BA LA NCE AR M WEIGH T
1 8. STABILATOR B ALANC E A RM
1 9. LOC KING C LIP

Stabilator Controls

19
3 3
6
1 1
1 0
Figure 19
2C8
1
1 2
1 5
9
14
2
Page 27-34
Reissued: July 1, 1993
27-30-00