Discharge Line Assemblies And Valves - Waterous AQUIS ULTRAFLOW Installation And Operation Manual

Safety Introduction

Discharge Line Assemblies and Valves

Subsystem Subsystem
1 Control box
2 Manual override switch
3 Power disconnect relay
4 Supply tank level sensors
5 Concentrate pump intake
select valve
6 Water pump pressure
transducer
7 Solution discharge pressure
transducer
8 Hydraulic control
9 Remote I/O
10 Terminating resister
Product Overview
Description Description
This connects to various components in the system and contains the programmable logic controller (PLC).
This disables the automatic control of the concentrate control valves.
This power relay enables and disables power to the DLA.
This signals to the control box whether the supply tank is at full or low. Alternatively, an installer supplied system can
display an approximate supply level.
This is an installer supplied, 2 position valve, and additional components that sources concentrate from an on-board tank
or an auxiliary supply. A signal is provided to the system to ignore the on-board tank sensors when sourcing concentrate
from an auxiliary supply.
This measures the pressure at the pump discharge.
This measures the pressure at the solution capable discharge.
This monitors and controls the hydraulic system.
This adds a node controller to the system for additional options required in your application.
This connects to the split CANbus cable female socket connector on the last DLA in the system.
Installation
|
11 62
Operation Maintenance