Connecting The Low-Flow Bypass Line - Waterous AQUIS ULTRAFLOW Installation And Operation Manual

Safety Introduction

Connecting the Low-Flow Bypass Line

2
M
F
M F
1
3
M F
Product Overview
|
57 62
Installation Operation
Use the illustration and instructions to install the
low-flow bypass line. To connect to the apparatus
plumbing, refer to: "Plumbing Layout" on page
52.
1 Connect the split CANbus cable to the CANbus
connector on the node controller.
2 Connect the male end on the split CANbus
cable to an upstream node controller, or to the
control box—the discharge CANbus connection.
Note: Use an additional CANbus cable if
necessary.
3 Connect the female end on the CANbus splitter
cable to next downstream node controller, or to
a terminal resister if this is the last downstream
node controller in the system.
Note: Use an additional CANbus cable if
necessary.
I-2254 L-1222-4