Home Decorators Collection JUNEDALE Use And Care Manual page 10

Assembly - Hanging the Fan (continued)
2
Hanging the fan
□
Carefully lift the fan-motor assembly (E) up to the slide-on
mounting bracket (A).
□
Insert the ball portion of the ball/downrod assembly (C)
into the socket of the slide-on mounting bracket (A).
□
Turn the ball/downrod assembly (C) clockwise until it is
seated with the tab of the slide-on mounting bracket (A)
aligned with the slot in the ball.
3
Preparing the remote control
NOTE: The frequencies on your receiver and hand unit have been
preset at the factory. Before installing the receiver, make sure the
dip switches on the receiver and hand unit are set to the same
frequency. The dip switches on the hand unit are located inside the
battery compartment.
NOTE: The remote control battery will weaken with age and
should be replaced before leaking takes place, as this will damage
the remote control. Dispose of used battery properly and keep the
battery out of the reach of children.
□
Remove the remote control (L) battery cover by pressing firmly on
the arrow and sliding the cover off.
□
Slide the dip switches (ZZ) to your choice of either up or down. The
factory setting is up.
□
Slide the dip switches (ZZ) on the receiver (K) to the same position
as set on the remote control (L).
□
Install the 23A 12V battery (included).
□
Replace the battery cover on the remote control (L).
□
Insert the silicone rubber stopper (OO) into the hole on the receiver
(K) to cover the dip switches.
K
10
A
C
B
DD
D
E
L
ZZ
ON
OO
1 2 3 4