Spectra T200 User Manual page 157

Chapter 5 — Operating the Library
Use the Soft Power Feature
The Soft Power feature disables the physical power button on the library
front panel and enables the soft power button on the General Status screen.
Using the Soft Power feature gives users with superuser privileges
exclusive control over powering the library off; other types of users cannot
power off the library, either by using the physical power button on the
library front panel or the Soft Power button on the General Status screen.
Follow these steps to power off the library using the Soft Power feature.
1. Log into the library as a user with superuser privileges (see
2. From the toolbar, access the General Status screen.
3. Using the stylus, touch the blue power button on the picture of the
Figure 85 The Soft Power button on the General Status screen.
December 2019
 The Soft Power feature is only available from the library's
Notes:
front panel touch screen interface; it is not available through
the BlueScale web interface (RLC).
 When you click the Soft Power button, you must respond to a
confirmation message before the library is powered off.
 The Soft Power feature must be enabled on the System Setup
screen before you can use it (see
page 108).
 The feature can only be enabled or disabled by a superuser.
User Interface on page
library.
Soft power
button
When the cursor comes near the button, it changes to a pointing finger,
as shown in Figure 85.
User Guide—Spectra T200, T380, and T680 Libraries
Enable Soft Power on
87).
Controlling the Library Power
Log Into the
158