Appendix 1: Tracker Event List - Sanav MU-201 S2 User Manual

Appendix 1: Tracker Event List

This table shows the different events/ messages sent from the device.
Basically, there are more than 6 different situations that trigger the device to respond its position and tracker
status messages as the following.
Note: Any event marks with letter "B" represents data which was not able to send to assigned route
immediately due to priority or mobile network service issue. The data will be sent after the issues are cleared.
Event
AUTO / BAUTO
MOVE / BMOVE
STOP/BSTOP
POLL / BPOLL
SOS / BSOS
LP
11F., No.2, Sec. 4, Jhongyang Rd., Tucheng Dist., New Taipei City 236, Taiwan (R.O.C.)
Tel: 886-2-22694456｜Fax: 886-2-22694451｜sanav@sanav.com
37
Description
When the device is set to report to assigned route in a given period of time, it will
send a report automatically with an AUTO message.
When any other event is triggered and the priority is greater than AUTO, the
Retrospective Location report will be saved to flash and report to assigned route
later.
When the device exceeds the movement threshold in Park/ Vibration detection
mode, it will trigger the MOVE event according to the setting.
When the device exceeds the Non-movement threshold in Park/ Vibration detection
mode, it will trigger the STOP event according to the setting
When sending polling command to poll the report, it triggers the POLL event.
When the SOS (Panic) function is activated, it triggers the SOS Event.
When the device is in 1 st low power (under 3500mV) status, it triggers the LP Event.
新禾航電
2019.09.11
文管中心
www.sanav.com
www.sanav.com