While Playing - Sony MZ-NH900 Operating Instructions Manual

While playing

Symptom
A disc is not played
normally.
A disc is not played
from the first track.
Playback sound skips. • The recorder is placed where it receives continuous vibration.
Sound has a lot of
static.
The volume of the
recorded track is low.
Volume cannot be
turned up.
No sound comes
through the
headphones/
earphones.
Virtual Surround or 6-
Band Equalizer does
not function or noise
is heard.
The volume from
connected speaker or
amplifier is low (when
analog connection)
The volume from the
headphones/earphones
is too loud.
The disc cannot be
played on another
component
Cause/Remedy
• Repeat play is selected.
, Press P-MODE/
• Playback mode is changed.
, Enter the Main play mode or Sub play mode to change back to
the normal play (page 45).
• Disc playing stopped before it came to the last track.
, Press the jog lever (NX/ENT) on the remote control or press
the 5-way control key (NENT) for 2 seconds or more to start
playing.
, Put the recorder on a stable place.
• A very short track may cause sound to skip.
, Try not to create a short track.
• Strong magnetism from a television or such device is interfering
with operation.
, Move the recorder away from the source of strong magnetism.
• The track was recorded in analog mode (in digital mode, the
recording level is automatically set to the same level as that of the
sound source). Or you used a connecting cord with an attenuator.
, Use a correct connecting cord without an attenuator.
• The recording level was low.
, Adjust the recording level manually while recording (page 38).
• AVLS is on.
, Release AVLS settings (page 74).
• The headphones/earphones plug is not firmly connected.
, Plug in the plug of the headphones/earphones firmly to the
remote control. Plug in the plug of the remote control firmly to
i/LINE OUT.
• The plug is dirty.
, Clean the plug.
• The "Audio Out" parameter is set to "Line Out".
, Set to "Headphone" (page 57).
• The "Audio Out" parameter is set to "Headphone".
, Set to "Line Out" (page 57).
• The "Audio Out" parameter is set to "Line Out".
, Set to "Headphone" (page 57).
• The component does not support Hi-MD.
, Discs used in Hi-MD
that supports Hi-MD.
to change back to the normal play (page 45).
mode
can be played only on components
91