Sony MZ-NH900 Operating Instructions Manual page 92

Symptom
The recorder skips to
the next or previous
group (or skips several
tracks ahead or
behind) when you
press the 5-way
control key towards
. or >.
The edited tracks may
exhibit sound dropout
during search
operations.
There is no R-channel
sound output when
playing a track
recorded from a
cassette deck or
through an amplifier,
or when listening to
sound from a cassette
deck or amplifier.
While editing
Symptom
"NotENOUGH
POWER TO EDIT"
appears and editing
cannot be done on a
1GB Hi-MD disc.
The lid does not open. • The power sources have been disconnected during recording or
Editing cannot be
done.
Non-audio data
cannot be erased
92
Cause/Remedy
• You pressed GROUP before pressing the 5-way control key towards
. or >.
, The recorder returns to normal if no operation is made for 5
seconds.
• This occurs due to the MiniDisc system limitation. The
fragmentation of data may cause sound dropout while searching
because the tracks are played in higher speed than normal playback.
• There is no R-channel output if the cassette deck or an amplifier is
connected with a monaural cord.
, Make sure to use a stereo connecting cord. If, however, the
connected equipment is monaural, there will be no R-channel
sound output even with a stereo connecting cord.
Cause/Remedy
• Editing is not possible when using a 1GB Hi-MD disc even when the
battery level indication shows enough power remaining while the
recorder is stopped or playing. This is because of a mechanism that
disables editing when the remaining battery power is estimated by
the recorder to be insufficient due to the high power consumption
required for 1GB Hi-MD disc editing.
, Connect the AC power adaptor to the recorder or insert a fully
charged rechargeable battery or a new alkaline dry battery.
editing, or the battery have been exhausted.
, Set the power sources again, or replace the exhausted battery
with new ones.
• The power source has been disconnected or a power outage has
occurred during editing.
, The editing done to that point is not saved to the disc. Do the
editing operation again.
• Non-audio data cannot be erased with the Erase function.
, Confirm the contents by connecting the recorder to your
computer. If it is okay to delete the contents, then perform the
Format function (page 73).