Adjusting The Steering Head Bearing Play; Lubricating The Steering Head Bearing - Husqvarna EE 5 2021 Owner's Manual

13 SERVICE WORK ON THE CHASSIS
13.12
13.13
52

Adjusting the steering head bearing play

M01718-10

Lubricating the steering head bearing

H02387-01
It must be possible to move the handlebar easily over the
entire steering range. There should be no detectable detent
positions.
» If detent positions are detected:
–
Adjust the steering head bearing play.
–
Check the steering head bearing and replace if
required.
Finishing work
–
Remove the motorcycle from the lift stand. (
Preparatory work
–
Raise the motorcycle with a lift stand. (
Main work
–
1
Loosen screws .
–
2
Loosen screw .
–
Loosen and retighten nut
Guideline
Nut, steering head
–
Using a plastic hammer, tap lightly on the upper triple clamp
to avoid stresses.
–
2
Tighten screw .
Guideline
Screw, top triple
clamp
–
1
Tighten screws .
Guideline
Screw, top triple
clamp
Finishing work
–
Check the steering head bearing play. (
–
Remove the motorcycle from the lift stand. (
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
Info
The steering head bearing is cleaned and lubricated
in the course of removal and installation of the lower
triple clamp.
( p. 52)
p. 45)
p. 45)
3
.
M20x1.5 10 Nm (7.4 lbf ft)
M8 20 Nm (14.8 lbf ft)
M8 20 Nm (14.8 lbf ft)
p. 51)
p. 45)
( p. 48)
( p. 49)