Husqvarna EE 5 2021 Owner's Manual page 52

13 SERVICE WORK ON THE CHASSIS
50
–
Position the upper triple clamp with the handlebar.
–
4
Mount nut
M01714-11
Condition
Individual installation position
–
Position the fork legs.
Guideline
Observe the position determined during removal.
Bleeder screws
Condition
Standard installation position
F02179-11
–
Position the fork legs.
Bleeder screws
The second milled groove (from the top) is flush with
the upper edge of the upper triple clamp.
–
Tighten screws
Guideline
Screw, bottom triple
clamp
M01817-10
–
4
Tighten nut
Guideline
Nut, steering head
–
Tighten screw
Guideline
Screw, top triple
clamp
–
Using a plastic hammer, tap lightly on the upper triple clamp
M01670-10
to avoid stresses.
–
Tighten screws
Guideline
Screw, top triple
clamp
–
Fix the magnetic switch cable to the handlebar with a new
cable tie.
, but do not tighten it yet.
5
are positioned toward the rear.
5
are positioned toward the rear.
6
.
M8 15 Nm (11.1 lbf ft)
.
M20x1.5 10 Nm (7.4 lbf ft)
7
.
M8 20 Nm (14.8 lbf ft)
8
.
M8 20 Nm (14.8 lbf ft)