Advertisement
STROMPI 3
Firmware Flash Manual
1. GENERAL INFORMATION
Dear customer,
thank you very much for choosing our product.
In following, we will introduce you to what to observe while starting up
and using this product.
Should you encounter any unexpected problems during use, please do
not hesitate to contact us.
www.joy-it.net
Pascalstr. 8 47506 Neukirchen-Vluyn
Advertisement
Table of Contents
Related Manuals for Joy-it STROMPI 3
Summary of Contents for Joy-it STROMPI 3
- Page 1 STROMPI 3 Firmware Flash Manual 1. GENERAL INFORMATION Dear customer, thank you very much for choosing our product. In following, we will introduce you to what to observe while starting up and using this product. Should you encounter any unexpected problems during use, please do not hesitate to contact us.
- Page 2 Remove the CAP jumper. Now set the flash jumper of the StromPi to ON and set the CAP jumper back to ON. Now put your StromPi on your Raspberry Pi and supply both with power via the micro-USB port (or USB-C). www.joy-it.net Pascalstr. 8 47506 Neukirchen-Vluyn...
- Page 3 If the flash process was successful, you should see the following: Now disconnect all power supplies, remove the CAP jumper, set the flash jumper to OFF and then set the CAP jumper back to ON. You can now use your StromPi with the new firmware. www.joy-it.net Pascalstr. 8 47506 Neukirchen-Vluyn...
- Page 4 SIMAC Electronics GmbH, Pascalstr. 8, D-47506 Neukirchen-Vluyn, Germa- Possibility of return in your area: We will send you a parcel stamp with which you can return the device to us free of charge. Please contact us by email at Service@joy-it.net or by telephone. Information on packaging: If you do not have suitable packaging material or do not wish to use your own, please contact us and we will send you suitable packaging.
Need help?
Do you have a question about the STROMPI 3 and is the answer not in the manual?
Questions and answers