Eagle III Installation And Operation Instructions Manual page 8

check the battery voltage. Most of the complaints we receive about
portable units result from stale batteries. Make certain the ones you buy
are fresh. Always remove batteries from the battery compartment before
storing the unit as dead batteries can leak and corrode the contacts.
In cold weather the efficiency of dry cell batteries drops with the tempera-
ture. We find it a good idea to have the Magna III Portable good and warm
along with the batteries before we leave home. If the batteries do lose a
charge, you can sometimes restore them by placing them in a warm room
or car interior. A better way is to replace them with batteries that have been
kept warm. Don't ever heat the batteries over an open flame or direct hot
air onto them. A fire or explosion could result.
PORTABLE TRANSDUCER ASSEMBLY
Assemble the transducer and bracket as shown below. Attach the
transducer to the bracket with the supplied hardware. Make certain there
is one washer on each side of the transducer, inside the bracket. Slide the
other washer over the end of the bolt and thread the nut onto it. Screw the
suction cup onto the bracket using the supplied screw and flat washer. Tie
the nylon cord through the hole in the top of the bracket. When using this
transducer, tie the other end of the nylon cord to the boat. This will help
prevent the loss of the transducer if it comes off the boat.
BOLT
WASHER
TIE
NYLON
CORD
HERE
NUT
WASHER
8
SCREW