Filling By Hardi Filler Chemical Inductor - Hardi MARRO TWIN FORCE 1000 Instruction Book

Filling by HARDI FILLER chemical inductor

Liquid chemicals
1. Fill the main tank at least
something else is stated on the chemical container
label). See section "Filling
of water".
2. Turn the handle at
the Suction
Manifold
towards "Main
tank". Close
remaining
valves.
3. Turn the
handle at the
Pressure
Manifold towards
"HARDI FILLER".
Close remaining valves.
Check that bottom valve A
at the FILLER is closed.
T020-0006
4. Engage the pump and set P.T.O. speed at 540 r.p.m.
or 1000 r.p.m. depending on pump model.
5. Open FILLER lid.
6. Measure the correct quantity of chemical and fill it
into the hopper.
NOTE! The scale in the hopper can only be used if the
sprayer is parked at level ground! It is recommended to
use a measuring jug for best accuracy.
1 / with water (unless
3
T042-0001
7. Open the bottom valve A and the chemical is trans-
ferred to the main tank.
8. If the chemical container is empty it can be rinsed by
the container rinsing device (if fitted). Place the
container over the multi-hole nozzle and press the
lever B.
WARNING! Do not press lever B unless the
multi-hole nozzle is covered by a container to
avoid spray liquid hitting the operator.
IMPORTANT! Rinsing device uses spray liquid to rinse
containers for concentrated chemicals. Always rinse the
chemical containers with clean water several times until
they are clean before disposal.
9.Engage the hopper rinsing device by opening valve C.
10.Close valve C again when the hopper is rinsed.
IMPORTANT! The hopper rinsing device is using spray
liquid for rinsing the hopper for concentrated chemical!
The FILLER must always be cleaned together with the
rest of the sprayer when the spray job is done.
11.Close valve A and the FILLER lid again.
12.Turn handle at the Pressure Manifold towards "Inten-
sive Agitation" and close remaining valves.
T020-0007
13.When the spray liquid is well mixed, turn handle on
the Pressure Manifold towards "Spraying" position.
Keep P.T.O. engaged so the spray liquid is continu-
ously agitated until it has been sprayed on the crop.
T020-0012
GB 08 03
23