Table of Contents
Advertisement
Of
Off-season stor
Of
f-season stor
f-season stor
f-season stora a a a a g g g g g e e e e e
Of
Of
f-season stor
When the spraying season is over, you should devote
some extra time to the sprayer.
If chemical residues are left over in the sprayer for
longer periods, it can reduce the life of the individual
components.
To preserve the sprayer intact and protect the compo-
nents, carry out following off-season storage program.
1. Clean the sprayer completely - inside and outside - as
described under "Cleaning of the sprayer". Make sure
that all valves, hoses and auxiliary equipment has
been cleaned with detergent and flushed with clean
water afterwards, so no chemical residues is left in
the sprayer.
2. Renew possible damaged seals and repair possible
leaks.
3. Empty the sprayer completely and let the pump work
for a few minutes. Operate all valves and handles to
drain as much water off the spraying circuit as possi-
ble. Let the pump run until air is coming out of all
nozzles. Remember to drain the rinsing tank also.
4. Pour appr. 50 litre (11 Imp.gal) anti-freeze mixture
consisting of 1/3 automotive anti-freeze and 2/3 water
into the tank.
5. Engage the pump and operate all valves and func-
tions on the MANIFOLD, operating unit, FILLER etc.
allowing the anti-freeze mixture to be distributed
around the entire circuit. Open the operating unit main
on/off valve and distribution valves so the anti-freeze
is sprayed through the nozzles as well. The anti-
freeze will also prevent O-rings, seals, diaphragms
etc. from drying out.
6. Lubricate all lubricating points according to the
lubricating scheme regardless of intervals stated.
7. When the sprayer is dry remove rust from possible
scratches or damages in the paint and touch up the
paint.
8. Remove the glycerine-filled pressure gauges and
store them frost free in vertical position.
9. Apply a thin layer of anti-corrosion oil (e.g. SHELL
ENSIS FLUID, CASTROL RUSTILLO or similar) on
all metal parts. Avoid oil on rubber parts and hoses.
10. Fold the boom in transport position and relieve
pressure from all hydraulic functions.
11. All electric plugs and sockets are to be stored in a
dry plastic bag to protect them against damp, dirt and
corrosion.
12. Remove the control boxes and the HARDI PILOT
control box + display from the tractor, and store them
dry and clean (in-house).
13. Wipe hydraulic snap-couplers clean and fit the dust
caps.
14. Apply grease on all hydraulic ram piston rods which
are not fully retracted in the barrel to protect against
corrosion.
15. To protect against dust the sprayer can be covered
by a tarpaulin. Ensure ventilation to prevent conden-
sation.
Preparation after off-season storage
After a storage period the sprayer should be prepared
for the next season in the following way:
1. Remove the cover
2. Wipe off the grease from hydraulic ram piston rods.
3. Fit the pressure gauges again. Seal with Teflon tape.
4. Connect the sprayer to the tractor including hydrau-
lics and electrics.
5. Check all hydraulic and electric functions.
6. Empty the tank for remaining anti-freeze.
7. Rinse the entire liquid circuit on the sprayer with
clean water.
8. Fill with clean water and check all functions.
GB 15 01
51
Advertisement
Table of Contents
