hergom COCINA ECLECSYS Installation, Use And Maintenance Instructions page 18

The stove has an access system to the chimney,
in order to make it easier to seal it, once
has been installed. To access it, proceed as
follows:
1. Remove the vitroceramic worktop from the
stove and the cast iron under-worktop
(figures 1 and 2).
2. Dismantle the draught rod (figure 3).
3. The access cover to the chimney is removed
together with the draught valve upwards
(figure 4).
Dismantling the vitroceramic glass worktop
Lift the worktop as shown in the following
figures, pull it towards the front and lift it.
1
2
Proceed in reverse order to mount the
vitroceramic glass worktop.
If you want to cook on the cast iron under
worktops, lift the vitroceramic glass worktop until
3
you get an angle of approximately 90°. Lower the
retaining rod that is located on the left-hand side
and put it into the hole in the framework of the
enamelled worktop.
ake sure that the retaining rod is properly fixed
and there is no possibility that the vitroceramic
glass worktop can come loose (Figure 8).
Before putting the vitroceramic glass worktop in
4
place, check that the cast iron under worktops
are centred with respect to the frame of the
worktop (Figure 9).
Take
vitroceramic glass worktop. Do it slowly to make
sure that it goes down easily without coming into
contact with the cast iron under worktops.If,
when lowering the worktop, it brushes against
the cast iron under-worktops, it means that the
18
5
6
7
special care when lowering the