Troubleshooting - Pyle PLRVST400 User Manual

TROUBLESHOOTING

Before going through the checklist, check wiring connection. If any of the problems
persist after checklist has been made, consult your nearest service dealer.
Symptom
No power
Disc cannot be
loaded or
ejected.
No sound
Wiring is not properly connected
Sound skips
The operation
keys do not
work
The radio does
not work. The
radio station
automatic
selection does
not work.
Cause
The car ignition switch
is not on.
The fuse is blown
Presence of CD disc inside
the player.
Inserting the disc in reverse
direction.
Compact disc is extremely dirty
or detective disc.
Temperature inside the car
is too high.
Condensation
Volume is in minimum
The installation angle
is more than 30 degree.
The disc is extremely dirty
or defective disc.
The built-in microcomputer is The built-in microcomputer is
not operating properly due to not operating properly due to
noise. noise.
The antenna cable is
not connected.
The signals are too weak.
Solution
If the power supply is connected
to the car accessory circuits, but
the engine is not moving, switch
the ignition key to "ACC".
Replace the fuse
Remove the disc in the player,
then put a new one.
Insert the compact disc
with the label facing upward.
Clean the disc or try to play
a new one.
Cool o or until the ambient
temperature return to normal.
Leave the player o for an hour or so,
then try again.
Adjust volume to a desired level
Check wiring connection
Adjust the installation angle
less than 30 degree.
Clean the compact disc,
then try to play a new one.
Press the RESET button. Front panel is Press the RESET button. Front panel is
not properly xed into its place. not properly xed into its place.
Insert the antenna cable rmly.
Select a station manually.
www.PyleUSA.com
15