Troubleshooting - Pyle PLRVST400 User Manual

TROUBLESHOOTING

Before going through the checklist, check the wiring connection. If any of the problems
persist after checklist has been made, consult your nearest service dealer.
Symptom
No power.
Disc cannot be
loaded or
ejected.
No sound.
Sound skips.
The operation
keys do not
work.
The radio does
not Work. The
radio station
automatic
selection does
not work.
www.PyleUSA.com
Cause
The car ignition switch is
not on.
The fuse is blown.
Presence of CD disc
inside the player.
Inserting the disc in
reverse direction.
Compact disc is extremely
dirty or defective disc.
Temperature inside
the car is too high
Condensation.
Volume is in minimum
Wiring is not properly
connected.
The installation angle is
more than 30 degree.
The disc is extremely dirty
or defective disc.
The built-in microcomputer
is not operating properly due
to noise
The antenna cable is not
connected.
The signals are too weak.
Solution
If the power supply is connected
to the car accessory circuits but
the engine is not moving,
switch the ignition key to "ACC".
Replace the fuse.
Remove the disc in the player
and replace with a new one.
Insert the compact disc with
the label facing upward.
Cool off or until the ambient
temperature returns to normal.
Leave the player off for an hour
or so, then try again.
Adjust volume to a desired level.
Check wiring connection.
Adjust volume to a desired level
Clean the compact disc, then try to
play a new one.
Press the RESET button.
Front panel is not properly fix into
its place.
Insert the antenna cable firmly.
Select a station manually.
18