DR 372111 Safety & Operating Instructions Manual page 32

Extended Top-
Discharge Chute
180°
Discharge
Ring
Figure 48
Lower
Discharge
Deflector
Figure 49
3-POINT HITCH DR
32
OPERATION
Locking
Pin
Adjusting the Extended Top-Discharge Chute Discharge Direction:
1. Pull the Hitch Clip and remove the Locking Pin (Figure 48).
2. Rotate the Extended Top-Discharge Chute to the direction desired.
NOTE: The Extended Top-Discharge Chute has a range of motion of 180˚ that spans
the front and both sides of the Chipper. There are 11 different hole settings at 18˚
increments that you can use.
Hitch
Clip
3. Line up the Locking Pin hole to the closest hole setting in the Discharge
4. Install the Locking Pin and secure it with the Hitch Clip.
Adjusting the Deflector Direction:
Higher
1. Grab the Deflector Handle and rotate the Deflector to the desired discharge
Discharge
MAINTENANCE
Deflector
Handle
Tools and Supplies Needed:

Lubricating the Extended Top-Discharge Chute:
1. Pull the Hitch Clip and remove the Locking Pin from the Discharge Ring
2. Apply some all-purpose grease in each hole of the Discharge Ring and
3. Rotate the Extended Top-Discharge Chute for the full 180˚ of rotation for a
4. Reposition the Extended Top-Discharge Chute to the desired angle and
® SELF-FEEDING™ CHIPPER
Ring.
position (Figure 49).
All Purpose Grease
(Figure 48).
Center Ring as you rotate the Chute.
few times to spread the grease inside the Discharge Ring.
insert the Locking Pin and Hitch Clip.