Triax TDcH 16S-I-Q User Manual page 12

•
Connect the Terr/Cable input to the corresponding output of a terrestrial or cable distribution. Make sure
that the input level are in the required level range!
•
Connect the attached main cable to the IEC connector.
•
Connect the mains cable to a mains socket with protective conductor connection. Thereby note the voltage
specified on the device.
This device has no power switch and starts immediately after connecting the operating voltage.
•
Configure the device as described in the chapter "Installation & Easy Setup"
•
If the programming is finished, connect the RF output to the cable network.
EN 12
TDcH Compact Headend