Subscribe to Our Youtube Channel
Related Manuals for Congatec conga-QMX8-X
Summary of Contents for Congatec conga-QMX8-X
- Page 1 (Revision Y.1) Sample Distribution Set for congatec Qseven 2.0 Development Quick Start Guide Revision 1.1 Copyright © 2019 congatec AG QX8X_SDS_q11...
-
Page 2: Intended Audience
In no event shall congatec AG be liable for any Copyright © 2019, congatec AG. All rights reserved. All text, pictures and incidental, consequential, special, or exemplary damages, whether based graphics are protected by copyrights. -
Page 3: Warranty
(c) arising from course of performance, course of dealing, or usage of trade. congatec AG shall in no event be liable to the end user for collateral or consequential damages of any kind. congatec shall not otherwise be liable for loss, damage or expense directly or indirectly arising from the use of the product or from any other cause. -
Page 4: Pinout Description
Hardware 1.2.1 Pinout Description The conga-QMX8-X pinout description is available at the link below. The pinout description lists which signals of the NXP i.MX 8QuadXPlus applications processor are routed to the Qseven connector. Sample Distribution Set Contents https://git.congatec.com/arm-nxp/imx8-family/doc/cgtimx8_pinlist/-/raw/ cgtqx8x_pinlist/cgtqx8x_pin_connection.xlsx The contents of the conga-QMX8-X sample distribution set are listed below: conga-QEVAL/Qseven 2.0 ARM... -
Page 5: Hardware Setup
2. USB 3.0 is only supported on port 0. USB ports 5, 6 and 7 are not supported. For more information, refer to section 5.2.7 "Universal Serial Bus (USB)" of the conga-QEVAL/Qseven 2.0 ARM User's Guide. Copyright © 2019 congatec AG QX8X_SDS_q11... -
Page 6: Boot Process
Software Boot Process The conga-QMX8-X boot process starts at Power On Reset (POR), where the hardware reset logic forces the ARM core to begin execution. The on- Starting Up chip boot ROM loads the boot container which usually consists of SCFW, Security Controller (SECO) firmware, ARM Trusted Firmware (ATF) and the bootloader binary (U-Boot). -
Page 7: Additional Information
Using the wrong source can cause damage to the hardware and/or loss of loadfdt Used during boot, loads the device tree blob file data. For the conga-QMX8-X Revision Y.1, only use sources from branches ending with "_cgtqx8x-Y1". There are several commands to change the behavior of the bootloader and Note to customize the boot process.
Need help?
Do you have a question about the conga-QMX8-X and is the answer not in the manual?
Questions and answers