Ivd Slave Device Setup; Ivd Slave Front Panel Connection; Table 2-3. Ivd Connections; Figure 2-7. Ivd Front Panel Connections Overview - Draytek Vigor VigorAccess IVD User Manual

2.3 IVD Slave Device Setup

2.3.1 IVD Slave Front Panel Connection

All connections are made on the front panel of the IVD except power connector. The following
figure shows the connections on the front panel of the IVD.
Factory Reset – A reset button is used to reset system, and then IVD will reboot to factory default
configuration.
Console – A RS232 serial interface is used to connect a local management computer.
MGN – A management interface with RJ45 interface is for Telnet management. Users can set
local PC (personal computer) as the same subnet as IVD and to manage IVD by CLI command.
UPLINK – Support one 1000M Ethernet ports to Internet. The interface can be used as for Telnet
management. Users can set local PC (personal computer) as the same subnet as IVD and to
manage IVD by CLI command.
PHONE – Connected to PSTN normally.
LINE – Connected to ADSL devices or telephones for users.
Port
Power Cord
Console (Serial)
MGN
UPLINK
PHONE
LINE

Figure 2-7. IVD front panel connections overview

Table 2-3. IVD connections

Type, Color
Cord, Black
Wire with lug
terminal
RS232, Grey
RJ-45, Blue
RJ-45, Blue
RJ-21,
RJ-21,
Connected to
AC Inlet
DC Inlet
Connect to PC RS232
port for debug
To Intranet with a
management host
To Internet management
To PSTN
To subscriber copper line
36
Version: 1.5
Remarks
100-240VAC
-42 ~ 56VDC
--