2.2.2 Master Console Port Connection
For the initial configuration, users need to use terminal emulator software on a computer and
connect it to a network module through the console port. Users can connect the RJ-45 end of the
console cable to the console port of the network module. On the other side, users can connect the
other end to a serial port of a computer.
The default login is "admin", password is "1234"
Example:
***********************************************************
*
***********************************************************
Press [ENTER] key within 5 sec. to download image...0
Please wait a minute...
Login:
2.2.3 Master Management Port Connection
Users can connect the RJ-45 cable to the Ethernet port of the computer. The IP address is
172.16.1.1 by default. The subnet of PC should be the same as default IP setting.
Admin> network outband
Example:
--------------------------------------------------------------------------------
OUTBAND INTF CONFIGURATION
--------------------------------------------------------------------------------
IP Address
NetMask
Vlan Id
Bootloader Version: V1.0.9
Figure 2-3. Master console port connection
: 172.16.1.1
: 255.255.255.0
: 0
Figure 2-4. Master management port connection
*
33
Version: 1.5