Table of Contents
Advertisement
To display the DSL module information inside
the master/slave device
1.
Login the specified DSL module.
2.
Type the following command to get the
DSL module information
-
$get system info
How to Save the Configuration
To save the configuration for the controller
Type the following command to save the
configuration. Next time, the saved configuration
will be invoked after powering on the device.
-
Admin>commit
C
o
n
f
i
g
u
r
a
t
C
o
n
f
i
g
u
r
a
t
To use Telnet for managing Master/Slave device, refer to the following sections.
Default IP Settings for Master Device
1. The default IP address of Outband (MGN
port): 172.16.1.1/255.255.255.0)
2. IP address for Inband (UPLINK port): 0.0.0.0
(disable)
How to Change Master IP Setting
Changing master IP address setting (for management) is allowed to suit personal requirement. Type
the command below to change the settings.
For Outband (MGN port connection) , please set as the following
-
Admin>network out <new-ip> <mask> [vlanid]
For Inband (UPLINK port connection) , please set as the following
-
Admin>network in <new-ip> <mask> [vlanid]
For the Status, please set as the following
-
Admin>network out or - Admin>network in
Note: The IP addresses for MGN port and UPLINK ports cannot belong to the same domain.
4
i
o
n
b
y
U
s
i
n
g
T
e
l
n
i
o
n
b
y
U
s
i
n
g
T
e
l
n
The results
You will get the following results:
To save the configuration for the DSL module
Type the following command to save the
configuration. Next time, the saved configuration will
be invoked after powering on the device.
-
$commit
e
t
e
t
Default IP Settings for Slave Device
Proprietary DHCP is configured on UPLINK port in
slave device by default. The IP address will be
assigned automatically when it connects to the master
device.
Quick Start Guide for VigorAccess
Advertisement
Table of Contents
