Table of Contents
Advertisement
Operation
Scanning
The XTRAK's Scanning feature allows you to search for active channels automatically.
There are two main scanning modes;
Open Scan (O.S)
Group Scan (G.S)
During SCAN the XTRAK only checks channels or frequencies that are in the SCAN
Memory, which are indicated by the MEM icon. The XTRAK maintains two SCAN
Memories; one for Open Scan (OS) mode and the other for Group Scan (GS) mode, to
give you flexibility and allow you to use the radio more effectively.
1. Press [SCAN] to start Scanning.
2. The SCAN icon flashes during scan.
3. The scan direction can be changed at any time by pressing [UP / DOWN].
4. Press [SCAN] to stop Scanning.
Master Scan (M.S) is a special scan mode which is described separately.
NOTE
Open Scan (OS) Mode
All UHF-CB, user-programmed extra RX channels have been added to the OS SCAN
Memory for convenience. To add/remove channels from OS SCAN Memory, refer to
p.23.
Allows continuous scanning of all selected channels. If an active channel is found,
scanning will stop on that channel. If the received signal ceases, the unit will wait 3
seconds for the signal to return, otherwise scanning resumes. After transmission in scan
mode, the unit will wait 20 seconds for the signal to return, otherwise scanning resumes.
To select the OS Scan Mode:
1. Press [MENU] and then press [UP / DOWN] key until 06 Scan Mode is highlighted.
2. Press [MENU] to select.
3. Press [UP / DOWN] to change the selection to Open Scan.
4. Press and hold [MENU] to save & exit from the menu mode.
The O.S icon displays.
If SCAN is deactivated while on an active channel, the XTRAK will
stay on that active channel. If no channels are active, the XTRAK will
NOTE
reinstate the starting channel.
UNIDEN XTRAK
21
UHF CB Transceiver
Advertisement
Table of Contents
