Table of Contents
Advertisement
Operation
• See the Controls and Indicators on page 6 for dedicated key functions.
• In addition to the dedicated key functions, many features are available in the MENU.
MENU Order List
01 Squelch
02 Duplex
03 Priority Watch
04 Pri/Inst CH1
05 Pri/Inst CH2
06 Scan Mode
07 M.Scan Code
08 Call Tone
09 BCL
10 Roger Beep
• Each MENU function is described in their respective operations.
To use the MENU
1. Press [MENU] and then press [UP / DOWN] to highlight a menu option.
2. Press [MENU] to select the option.
3. Press [UP / DOWN] to highlight a setting option.
4. Press and hold [MENU] to store the setting.
Turning on the Power
Press and hold [POWER].
Low-Voltage/High-Voltage Alert
Th XTRAK can operate on 12VDC (13.8V) or 24VDC (27.6V) power supply,
with the range between 10.2VDC to 28.8VDC.
If the power supply voltage exceeds 30VDC, an alert tone sounds and
HI DC flashes for 5 seconds. The power source must not exceed 32VDC
otherwise permanent damage may occur to your radio, which may not be
NOTE
covered by the manufacturer's warranty.
If the input voltage falls below 10VDC, LO DC flashes for 5 seconds. The
power turns off automatically if voltage falls below 9.0VDC.
Switch your XTRAK OFF and disconnect it from the power source, before
locating the cause of the power supply problem.
UNIDEN XTRAK
11 Key Beep
12 Alpha tag
13 Speaker Select
14 B.light/Dimmer
15 Replay (RX Rec.)
16 Scramble
17 Microphone Gain
12
UHF CB Transceiver
Advertisement
Table of Contents
