Record Mode - Uniden iGO CAM 75 Owner's Manual

Record Mode

To record a video, ensure that a valid micro SD card (not
supplied) is inserted in the given slot. Also note, that inserting/
removing the SD card when the device is recording causes the
NOTE
device to shutdown and in worst case malfunction.
Using the iGO CAM 75/75R you can record videos.
Press and hold the M button to switch between Record, Picture and Playback
modes.
Recording
When connected to a car charger with power, the unit automatically goes into
the record mode and starts recording.
A flashing red dot icon and a recording timer indicates that the device is
recording. To stop recording, press OK and the red dot disappears, indicating
that the recording has stopped.
Protect the Current Recording
While recording, if you want to lock the current recordings, then press the
M button. Those recordings have been locked and will not be overwritten by
normal video recordings.
This also applies when the G-Sensor registers an impact while recording.
Rear Camera
Rear Camera helps you capture rear footages. Insert the rear camera cable
into the front camera and the rear camera. The footage from the rear camera
should be visible on the screen.
Always check the label on the rear camera cable to ensure the cable is
connected to the corresponding connector port. Otherwise, the rear camera
video feed will not display on the front camera screen.
UNIDEN iGO CAM 75/75R
11
Vehicle Recorder