Transport; Instructions On Machine Transport; Shock Load During Transport Und Storage - Bosch Rexroth MKE Operating Manual

38 / 74

Shock load during transport und storage

Storage Measures for commissioning
time /
months
> 1 > >
12 60
● Replace bearings
● Replace encoder
7.2

Transport

The motors must be transported in their original
package taking classes 2K11, 2B1, 2C1, 2S5,
2M4 specified acc. to DIN EN 60721-3-2 into
account.
Please observe the following classification limita-
tions:
Table 14: Classification limitation
(DIN EN IEC 60721-3-2)
Transport
Ambient conditions
Relative humidity
Shock load
7.2.1 Instructions on machine trans-
port
Do not remove factory-fitted transport protection
devices such as dust protection, shaft protec-
tion, blind screw fittings until the motors are
used. Keep the transport protection devices for
later use.
NOTICE
Never touch the connection points of electro-
static sensitive devices!
−
Mounted components (e.g. temperature
sensors, encoder) can contain parts sus-
ceptible to electrical discharge (ESD).
Observe the ESD safety measures.
Bosch Rexroth AG
-25 ... +70 °C
5 ... 75 %
⮫ Chapter 7.3 "Shock
load during transport
und storage "
on page 38
MKE Synchronous Servomotors
WARNING
Risk of injury and material damage due to
improper handling during transport!
−
Only use hoisting gear suited for the weight
of the motors. Use lifting sling belts or lifting
eye bolts. Secure the lifting eye bolts before
use.
Never walk under hanging loads.
−
Never lift the motor on the shaft.
−
Use suitable protective equipment and pro-
tective clothing during transport, and wear
safety shoes.
Fig. 5: Lifting and transporting motors
•
Before transporting the motor, determine the
weight of the motor. For more details about
motor weight, please refer to the type plate
or the project planning manual (Technical
data).
•
Adjust the carrying capacity of the lifting
device to the motor weight.
•
If provided by the manufacturer, all lifting eye
bolts must be used and tightened before use.
•
Avoid increased transport vibrations.
•
Remove any existing transport locks prior to
commissioning and keep them.
7.3 Shock load during trans-
port und storage
Function-impairing effects are avoided as long as
the specified limits are complied with.
1
R911402016, Edition 02