Error Messages; Remote Control - Sony STR-DA3400ES Operating Instructions Manual

The system cannot receive satellite
channels at all.
• The receiving condition is not good. Move
the antenna to the place where the
condition is good.
• Check that you subscribed to the desired
satellite radio service (see page 74).

Remote control

The remote does not function.
• Point the remote at the remote sensor on
the receiver.
• Remove any obstacles in the path between
the remote and the receiver.
• Replace all the batteries in the remote with
new ones, if they are weak.
• Make sure that the command modes of the
receiver and the remote are the same. If the
command mode of the receiver and the
remote are different, you cannot operate
the receiver with the remote (page 38).
• Make sure you select the correct input on
the remote.
• When you operate a programmed non-
Sony component, the remote may not
function properly depending on the model
and the maker of the component.
138 US

Error messages

If there is a malfunction, the display window
shows a message. You can check the condition
of the system by the message. See the
following table to solve the problem. If any
problem persists, consult your nearest Sony
dealer.
PROTECTOR
Irregular current is output to the speakers, or
the upper panel of the receiver is covered
with something. The receiver will
automatically turn off after a few seconds.
Check the connection of speakers and turn
on the power again.
For other messages, see "Message list after
Auto Calibration measurement" (page 49),
"XM Radio message list" (page 83), "SIRIUS
Satellite Radio message list" (page 84) and
"DIGITAL MEDIA PORT message list"
(page 93).
Reference sections for clearing
the receiver's memory
To clear
All memorized settings
Customized sound fields
See
page 37
page 64