The Receiver - Sony STR-DA3400ES Operating Instructions Manual

Multi channel av receiver
Hide thumbs Also See for STR-DA3400ES:
Table of Contents

Advertisement

Inserting batteries into the
remote
Insert two R6 (size-AA) batteries in the RM-
AAL017 Remote Commander.
Insert two R6 (size-AA) batteries in the RM-
AAU039 Remote Commander.
Observe the correct polarity when installing
batteries.
RM-AAL017
Notes
• Do not leave the remote in an extremely hot or
humid place.
• Do not use a new battery with old ones.
• Do not mix manganese batteries and other kinds of
batteries.
• Do not expose the remote sensor to direct sunlight
or lighting apparatuses. Doing so may cause a
malfunction.
• If you do not intend to use the remote for an
extended period of time, remove the batteries to
avoid possible damage from battery leakage and
corrosion.
• When you replace the batteries, the programmed
remote codes may be cleared. If this happens,
program the remote codes again (page 122).
Tip
When the remote no longer operates the receiver,
replace all the batteries with new ones.
About the command mode
The receiver and the remote use the same
command mode.
If the command modes of the receiver and the
remote are different, you cannot use the
remote to operate the receiver.
If the command modes of both the receiver and
the remote are those of the initial setting (AV
SYSTEM 2), it is not necessary to reset them.
38
US
RM-AAU039
You can switch the command mode (AV
SYSTEM 1 or AV SYSTEM 2) of the receiver
and the remote. If both the receiver and the
other Sony component respond to the same
remote command, switch the command mode
of either the component or the receiver to
another command mode so that the component
does not respond to the same remote command
as the receiver.
To switch the command mode
of the receiver
POWER
2CH/A.DIRECT
While holding down the 2CH/
A.DIRECT, press POWER to turn on

the receiver.

When the command mode is set to "AV2",
"C. MODE AV2" appears on the display
window.
When the command mode is set to "AV1",
"C. MODE AV1" appears on the display
window.
To switch the command mode
of the RM-AAL017 remote
1
THEATER
SHIFT
TV
1
2
VIDEO1
VIDEO2
4
5
SAT
TV
7
8
TUNER
PHONO
-/-- 0/10
HDMI1
HDMI2
XM
SIRIUS
2CH/
A.DIRECT
A.F.D.
INPUT
RESOLUTION
MODE
1
2
ZONE
AMP
3
TV INPUT
3
BD
DVD
6
WIDE
MD/
SA-CD/
TAPE
CD
9
D.TUNING
MULTI
DMPORT
IN
4
ENT/MEM CLEAR
HDMI3
HDMI4
SOURCE
MOVIE
MUSIC
NIGHT
SLEEP
MODE
GUI
MODE

Advertisement

Table of Contents
loading

Table of Contents