Table of Contents
Advertisement
7. APPENDIX
1
[Enable Synchronization]
2
[3D Playback Mode]
3
[Multicast Group Address]
If the 'Use Master SPL' option is selected during configuration, the SPL playing on the master server will be
automatically copied and loaded on the slave server. SPL content must be loaded on the slave server before
playback is started.
1.
Create and load an SPL on the 'master' server.
2.
Make sure the 'slave' server has content and KDM required for this SPL.
3.
Start playback from the 'master' server.
4.
The 'slave' server will automatically start playback with the same SPL on the 'master' server.
If the 'Use Slave SPL' option is selected during configuration, the 'master' server will load and play an SPL
with same name on the 'slave' server. This SPL must be prepared on the slave server before playback is
started.
1.
Create and load an SPL on the 'master' server.
2.
Create an SPL with same name on the 'slave' server.
3.
Start playback from the 'master' server.
4.
The 'slave' server will automatically start playback of the SPL with the same name.
Notes: The above operation implies that content must be downloaded on both servers used for sync
playback. For encrypted content KDMs are needed for both the servers and these must be ingested to the
respective servers prior to playback.
The following table shows video output mode for 2D and 3D SPLs.
This can be used to configure projector macros for IMB synchronized playback.
SX-4000 Standalone Integrated Media Block™
User Manual
Setting this option will enable synchronized playback with another
system.
[Mode]
Select the IMB synchronized playback mode.
The "Master Server" is used to control playback for IMB
synchronized playback mode.
The "Slave Server" will play in sync with the "Master Server".
Playback control must be done from the "Master Server".
Play the left or right eye frames for 3D playback on this server. This
can be changed to match the projector placement for this server.
Set the multicast group address where the synchronization signal is
sent and received on both systems. This setting must be the same
on both master and slave servers.
- 166 -
September 26, 2016
Advertisement
Table of Contents
