Advertisement
To do so, press the "FUN" key and choose
option
5,
which
CONFIGURATION.
F6:
Various
5.1. INPUTS
Normally the INPUTS are already configurated
and prepared in the circuit in the factory, so the
following data is already configurated in memory.
If you choose option 2 (INPUTS) of the menu of
CONFIGURATION, you will see the following screen:
Number of input= 0
ANALOGICAL INPUTS
The maximum number of analogical sensors to
be connected is 8.
Every
sensor
corresponds to the input to which it is connected. This
input
has
already
configurated in the factory.
One
sensor
can
programmes.
The number of measure unit is used to give a
name to the type of value which controls the sensor.
Measure unit= 01
Here is a list of the measure units.
01- Temperature
ºC
02- Relat. humidity
%HR
03- Lighting
Klx
04- Relation
%
05- Speed
m/s
06- Direction
º
07- Acidity
pH
Every sensor has a tare (calibration) in relation
to a pattern. It is important not to modify this value,
unless a calibration has been done.
The maximum value of the tare is + 120 or 12.0.
Tare= 03.5%HR
To modify the value of the tare we have to
calculate the error of the reading of the sensor and add
or deduct it to the value of the tare.
shows
the
MENU
1
3
is
given
a
number
been
predetermined
give
value
to
08- Radiation
09- Units
10- Pressure
11- Flow
12- Flow
13- Carbon dioxide C02
14- Ammonia
76.3
Example: Tare = 03.5% HR
OF
If the correct value, according to the pattern,
was 75.0% HR, compared with the value of the
reading (76.3) there is a difference of minus 01.3%,
which has to be deducted from the value of the tare
(3.5 - 1.3 = 2.2%) resulting as follows: Tare =02.2% Hr
75.0.
If the tare has to be negative, enter first the
value and then press the key "-".
To the right of the value of the tare it indicates
the value of the sensor; this will be useful in the
programmes which give us averages of two sensors,
being here where you can see sensor by sensor.
To escape, enter the sensor "0" or press "FUN"
or "CON".
DIGITAL INPUTS
The
programme, can be used as external conditioners of
the programmes (for levels, etc) or as counters of
impulses (to register the consumption of water and
feed, etc).
To configurate them, when the screen demands
the number of input, answer with "9".
The next question will appear on the screen:
which
and
With "Yes" it will be input of counting, with "No" it
several
will be conditioning input.
Answering "Yes", the next question will be :
The value of impulse corresponds to the
quantity equivalent to every impulse received from a
counter of water, weight, etc. The maximum value is
12.0.
Wm2
For the input nº 2 it will ask the same.
Uds
Psi
m3h
l/h
NH3
two
digital
inputs
Counting 1
(Yes/No)=Yes
Counting 1
(Yes/No)=Yes
Impulse value 1=
7
76.3
included
in
the
01.0
Advertisement
