Advertisement
14
The first screen that is displayed when we press
the key "CON", informs about the time and date. It also
indicates the quantity of anomalies that have taken
place or if the equipment is at STOP.
Mon. 15:23 17/07/00
A102
Mon. 15:23 17/07/00
A102
The other screens of consult show us the data
of every one of the programmes.
In the upper line it indicates the number of the
programme that is being consulted, then the text and
at the right the value of the input of the sensors.
At the lower line it shows the value of the outlet,
both in Manual and in Alarm.
The values of the inputs and outlets are updated
on the screen every second.
P05
TERM-1 E 18.9 ºC
S Start(man.) ALARM
The value of the input changes in the timing
programmes (type 3) as no value of sensor is
indicated, but we indicate the value of time that is left
to finish the working. If it is in hours and minutes, the
format is 00:00 if it is in minutes and seconds 00.00.
And, at the right of the lower line it shows in brackets
the number of cycles that are left to finish.
P08
TMP-0 E 01:33
S Pause
The value or state of the outlet can vary
according to the type of working, here are some
examples:
S Start
S Stop
S 000 %
S 100 %
S Open
S Close
S Pause
S Paus. O
S Paus. C
An asterisk (*) will appear between the "S" and
the value of outlets, in the programmes that in that
moment are being conditioned by another programme
or by a digital input, to indicate so.
An arrow up or down can also appear here, in
the
programmes
with
proportional action, indicating that the value of outlet
Anomalies=05
*STOP*
(02)
analogical
outlet
or
has reached the maximum or minimum programmed
value.
of
Advertisement
