Advertisement
Take 1pcs rear cover, put down the rear cover
and push the rear cover on the positions marked
S14
as the picture below shown for mechanisms
engagement.
Use a Philips-head screwdriver to tighten 4pcs
screws for locking rear cover with the assembled
unit, to tighten 2pcs screws for locking the rear cover
S15
with bracket chassis module.
(No.1~4 screw size=M4x11; Torque=10 12kgfxcm;
No.5~6 screw size=M4x6; Torque=10 12kgfxcm)
2
4
Stick 2pcs labels on the specific positions as the
picture below shown. Take 1pcs stand riser and
S16
1pcs stand base, assemble the stand base with
stand riser. Insert the stand-riser into monitor groove
until it snaps into its place.
4. Disassembly and Assembly Procedures
~
~
3
1
5
6
L
ift up the monitor to checking the gap between the
front bezel with panel module , then provide power
S17
supply and a video signal to the monitor, then turn
on the monitor for functionality check.
Advertisement
